The laser cutting machine should do the relevant trial run test and adjustment

After the laser cutting machine is installed, it cannot be put into operation immediately, and relevant trial run tests and adjustments need to be done. Because many people rush into use after installation, the accuracy of the cutting machine equipment has not been adjusted properly, resulting in cutting failures and poor performance. So the following editor will talk about how to adjust the accuracy of the device.

Adjust the light spot to a smaller size and start processing

1. When the spot of the focused laser is adjusted to be smaller, the initial effect is determined by spotting, and the focal length is determined by the size of the spot effect. We only need to find the small laser spot, and then this position is better. Process the focal length to start processing work.

Adjust the position several times to find a smaller spot

2. Debugging at the front of the cutting machine, we can use some debugging paper, the scrap point of the workpiece to determine the accuracy of the focal position of the laser cutting machine, move the position of the height of the upper and lower laser head, the size of the laser point will have different size changes when shooting. Adjust the position several times to find the smaller spot position to determine the focal length and suitable position of the laser head.

How to judge the cutting accuracy of the equipment

3. After installing the laser cutting machine, install a scribing device on the cutting nozzle of the cutting machine. The scribing device draws a simulated cutting pattern, which is a 1 meter square. A circle with a diameter of 1m is built in, and four corners are drawn diagonally. After the stroke is completed, measure it with a measuring tool. Is the circle tangent to the four sides of the square? Is the length of the diagonal of the square √2 (the data obtained by opening the root is approximately: 1.41m), and the central axis of the circle should be equally divided into the sides of the square and the points in the center. The distance between the intersection of the axis and the two sides of the square to the intersection of the two sides of the square should be 0.5m. By testing the distance between the diagonal and the intersection, the cutting accuracy of the equipment can be judged.

UV-Laser  | grüner Laser  | UV-Laser  | UV-DPSS-Laser  | Nanosekundenlaser  | UV-Laserquelle  | Festkörperlaser

Führen Sie vor der Verwendung eine detaillierte Inspektion und Einstellung der Genauigkeit durch

Daher ist es notwendig, ob nach der Installation der Laserschneidmaschine oder vor jeder Inbetriebnahme, eine detaillierte Inspektion und Einstellung ihrer Genauigkeit durchzuführen, die nicht nur den späteren Betrieb der Schneidmaschinenausrüstung besser gewährleistet stabiler und genauer. , Kann auch das Auftreten von Geräteausfällen effektiv reduzieren.